Why Your Garage Door Springs Deserve a Check-Up
You must periodically check your garage door extension springs for damage. However, it’s tricky to manipulate torsion springs as they can cause injuries due to their tension.
No risk is as big as neglecting severe spring damage. Poor closing or opening of the door exposes the inner space to theft. Moreover, a broken spring implies a more hardworking opener motor.
To avoid these issues, it’s highly recommended to contact a professional garage door service provider to bring back security and convenience when using your door.
The Top Tools for Professional Garage Door Spring Repair
- Proper work gloves- You will need these sturdy gloves for ultimate protection.
- A stable scaffolding or a step ladder– Look for a firm step ladder or a scaffolding to work safely at height.
- Necessary measurement essentials– Be ready with a measuring tape to find the spring length and a ruler to measure spring dimensions. You may also need adjustable pliers for gripping many components firmly.
- Parts for adequate replacement– You need two sets of replacement torsion springs (must be heavy-duty and identical). These springs will ensure proper balance and lifting mechanisms.
- Spring adjustment needs– Have proper winding bars for unwinding and winding torsion springs safely. Also, have those vise grips to hold the components firmly while making adjustments.
Spring Swap 101: How to Replace the Garage Door Springs
Step 2: Loosen Screws Safely – Use a winding bar to hold each spring while loosening the set screws. Position the ladder away from the springs for safety. Insert the winding bar into the winding cone’s hole, then loosen the screws. Repeat on both sides.
Step 3: Unwind the Springs – You’ll need two winding bars. Place one at a 90-degree angle to the other and turn them ¼ turn at a time until all tension is released. Alternate between springs for balance.
Step 4: Remove Bolts and Nuts – With the tension released, remove the nuts and bolts, sliding the springs towards their brackets using a wrench.
Step 5: Disconnect Components – Secure the torsion tube with a C-clamp. Loosen set screws on the lift cable drums and disconnect the cables before removing the torsion springs.
Step 6: Measure Spring Length – Remove the springs and measure their length from end to end with a tape measure.
Step 7: Coil Size and Inner Diameter – Measure the inner diameter of one spring end accurately. To find the coil size, measure the length of 10 coils and divide by 10.
Step 8: Get Replacement Springs – Finally, research and order replacement springs using the measurements of the old ones. This careful approach ensures a successful spring swap!
Final Thoughts: Professional Replacment Expert Help When Needed
Although you now understand how to replace garage door springs, it’s also important to recognize when to seek professional help. If you’re unsure at any point, therefore, contacting a garage door repair expert can ensure the job is done safely and efficiently